FAST Firmware changes

[rstehle]

I received my FAST parts and PCB's today, and have begun the adventure. I have a question regarding making changes to the firmware based on the number of segments I am using, which is 4, or 28 leds. I entered 28 where it looked like it needed to be, but my build failed. Could one of the experts enlighten me as to where the 28 goes?
Thanks,
Randy

[jklingert]

You just change it in one place, in the section of the code below the data tables the line that says:

incf full, 1 ;Was easier than explaining add 1 to LED count.
movlw d'56'
movwf fall_count ;######## Set number of LEDs attached to controller ie. 3 segments = 21

change the 56 to 28:

incf full, 1 ;Was easier than explaining add 1 to LED count.
movlw d'28'
movwf fall_count ;######## Set number of LEDs attached to controller ie. 3 segments = 21

[rstehle]

That did it! Thank You. (I was changing both of the 56's to 28, and it wouldn't work............)