FM02 SMA connector broken?

[IdunBenhad]

Hi:
This can be fixed with a little solder. Carefully sand off the plating of both parts and again carefully, solder the two pieces together. Do not get the connector too hot, as it could melt the insulation around the center pin.

This is a lot easier than trying to replace the whole connector.

[imbluenote]

Hi:
This can be fixed with a little solder. Carefully sand off the plating of both parts and again carefully, solder the two pieces together. Do not get the connector too hot, as it could melt the insulation around the center pin.

This is a lot easier than trying to replace the whole connector.

That is actaully what i ended up doing. I tested it out afterwards and seems to be working fine.

Chris - I think i might be good.