What controllers are people using for 5050 LED Strips?

[chilloutdocdoc]

With all 4 of my Ren64 boards running PWM I still need zero crossing to reset the board.

Are you running the DC firmware? From what I understood the DC firmware didn't require the ZC signal.

[budude]

You shouldn't need the H11AA1 on the Ren64 - there is a pull-up on that line (R14 - 27K) for all the PICs so MCLR doesn't float w/o it. I know for the DMX code you have to indicate it's a DC build - not sure if there's the same thing in the standard serial code. The Ren48LSD doesn't have the H11AA1 and it works fine and the Ren64 uses the same code.

[Henedce]

With all 4 of my Ren64 boards running PWM I still need zero crossing to reset the board.
Are you running the DC firmware? From what I understood the DC firmware didn't require the ZC signal.

Firmware was done by Wjohn so not 100 percent sure .. May also be that I bring in 5VDC for my supply rather than the 6.3 VAC specified.

[Hunter310]

I use the 48LSD to control my 5050's.....it works great!
This year, I will be adding more 5050's to my display and plan on controlling them with the 48LSD controller.

Steve E.