HLS Sequencer - Beta - Free to use

[JHinkle]

I just released 4F.

You can now create Preview Vectors for Pixel Plane .... NO - not your blinky -- but the Preview shows when the Pixel Plane is active.

You now have a Brightness Control for Prieview - make it darker or brighter - to your own liking.

Time scale has been changed to reflect Min:Sec.subsec --- this should make all of the music inclined people (not me) happy.

Joe

[angus40]

Outputting from HLS.
In the Manage Com Ports
com port 4, 1 stop bit , non parity and Baud rate 115200
That’s all good for RJ’s Lynx Dongle (Entec Pro)
In the Manage Universe window
Universe channels start and stop are all set .
Transport is com
Status is 4
Protocol How do I set this for Lynx dongle (Entec Pro)
Jess

here jess

https://vimeo.com/43290354

[budude]

Joe I'll give your Open image a test sometime tomorrow.

[jess_her]

Thanks Angus40,
I like the software a lot but there have been some duh moments trying to get my head wrapped around HLS. Where I went wrong this time was thinking protocol in the manage windows universe window, trying to click on the protocol button and protocol text box and not getting any ware. The Duh moment came in where you need to click on Transport text box to get the transport type then click on protocol text box to get protocol type.
One request Joe , Is there a way to put the HLS version in the blue HLS title bar at the top of the program? It’s probably self updating, but it’s nice to know
Man you can pound out program revs
Jess

[angus40]

The version is in the bottom right corner of the hls screen .

[JHinkle]

Thanks Angus40,
One request Joe , Is there a way to put the HLS version in the blue HLS title bar at the top of the program? It’s probably self updating, but it’s nice to know
Man you can pound out program revs
Jess

Jess - Version is noted in lower right corner.

Joe

[budude]

Joe I'll give your Open image a test sometime tomorrow.

Joe - I sent you a couple PM's - basically the Enttec-Open version does not seem to work. I tested the HW using Vixen first and then tried HLS with your sequence and another quick one that I put together but it did not work. I then tried my RPM dongle and it picked it up as an FTD245 OK and I selected Entec-Pro - but it does not work either. I have the outputs enabled/active - maybe I'm doing something wrong...

[angus40]

I am using rpms entec pro dongle without issue Brian.

Are your pics flashed with dmx ?

[JHinkle]

Thanks for your help Brian.

Version 4G is on my site with Entec OPEN working.

I had forgotten to added the required break signals.

Joe

[jess_her]

Joe, Angus40, somebody
I now identified RJ's dongle (entec pro) in Manage universe window. Transport - USB-DMX, Protocol - Entec Pro, USB serial number DPE00VX6 DPL-USB245M
Active is checked in Manage Universe, Output sequence is checked in the main design window, no joy.
I think RJ uses vertial com port drivers for his dongle.
HLS uses Dll outputs to the dongles.
SO I have to change com port drivers in RJ's dongle to have Dll drivers in RJ's dongle, right????