DMX to WS2801 Pixel Bridge

[Matt_Edwards]

RPM,
Do you have an updated firmware for the Quad DMX to WS2801 Pixel Bridge?

[RPM]

RPM,
Do you have an updated firmware for the Quad DMX to WS2801 Pixel Bridge?

I'll attach it here along with the schematics.

Robert

[enlightener]

Hi RPM,

Thanks for posting this DMX bridge! I built a single string version using the Atmega328 and it works great. The only thing I noticed is that it will not control more than 25 RGB LEDS (75 channels) using Vixen. I know the 50 LED string is good because it works using some stand alone Arduino programs. Any ideas?

Regards,

-Tim

[fathead45]

hey rpm, i just seen this and have some questions that i didnt see replied to or were answered but never heard if they were implemented

-Can you eventually be able to put a full univ on a single port?
-I seen you talked about hyperdmx in the 4 port. did that ever get implemented? if it did will the e131 to dmx support it as well?
-any idea on the max refresh rate will be with a maxed out board?

i guess that is it for now. im just trying to research all my options for next year as i dunno the status of the TP3244

[enlightener]

Hi RPM,

The problem is solved.

It turned out to be a Vixen setup issue. I set the channels to 150 on the main screen, but I did not initialize the DMX interface to have 150 channels when the sequence was first created.

It works perfect now with all 150 channels.

Thanks again,

-Tim

[mstevica]

I'll attach it here along with the schematics.

Robert

Do you have an updated pcb and .hex for the Quad DMX to WS2801 Pixel Bridge?

[mstevica]

RPM gave you to set the hex for this?
Thank in advance for your response!

[cenote]

Is there any chat about these, for another board run? Be interesting on getting a couple.

[Bretk]

I'd be interested in a few of the singles too

[Zeph]

I'm interested too, if this project resurfaces.

I hope RPM is ok.