renard to DMX

[mmulvenna]

Can someone point me to a thread/WIKI on what is needed to convert the RENARD 24 to DMX. I know I need different firmware and a DMX dongle (where to get it), but there has been references to a REN to DMX board earlier. My senior moments are getting in the way again.:confused:

[budude]

http://www.doityourselfchristmas.com...enard_Firmware points to the .asm code (you need MPLAB IDE to compile) for DMX. You can set the starting address in the .asm code file. I would suggest getting RPM's Enttec Pro-like dongle clone - not sure he has any boards available but give him a ping. I seem to recall the pinout is a bit different between the Renard and the dongle but that is a simple cable build. Don't know anything about a REN to DMX - maybe you're thinking of DMX-Grinch converter?

[mmulvenna]

http://www.doityourselfchristmas.com...enard_Firmware points to the .asm code (you need MPLAB IDE to compile) for DMX. You can set the starting address in the .asm code file. I would suggest getting RPM's Enttec Pro-like dongle clone - not sure he has any boards available but give him a ping. I seem to recall the pinout is a bit different between the Renard and the dongle but that is a simple cable build. Don't know anything about a REN to DMX - maybe you're thinking of DMX-Grinch converter?

Thanks Budude, I understand all of that what I was referring to is this reference to REN toDMX that I dont understand. He has since edited out the reference of the ren to DMXboards he had for sale. Perhaps he was referring to RPM's boards.

Thanks again

[mheuer]

I don't know anything about them at all, but I think I've seen those mentioned on cbell's website maybe?

http://christmasinbrewster.com/category/dmx/

Hope that helps,
Mike.

[cbell]

I don't know anything about them at all, but I think I've seen those mentioned on cbell's website maybe?

http://christmasinbrewster.com/category/dmx/

Hope that helps,
Mike.

There are several posts on my site that talk about my adventures with getting my Ren24 working with DMX, but ultimately the best information I had came from this post that Phil wrote.
http://www.doityourselfchristmas.com...9060#post39060

[mmulvenna]

There are several posts on my site that talk about my adventures with getting my Ren24 working with DMX, but ultimately the best information I had came from this post that Phil wrote.
http://www.doityourselfchristmas.com...9060#post39060

Thank you very much