Fuse holder

[Josh]

does anyone have extra fuse holders from the Coop SSR design?
im looking to pick up all 16 of them perferably.

hoping someone ordered a lot as its cheaper the more you get

[NogginBoink]

If you're feeling particularly brave, you could just jumper the two pads on the PCB for almost no cost at all.

You'll have to gauge your risk tolerance against the probabilities that something might go wrong without a fuse.

[xmus]

If you're feeling particularly brave, you could just jumper the two pads on the PCB for almost no cost at all.

You'll have to gauge your risk tolerance against the probabilities that something might go wrong without a fuse.

You can buy solder in fuses that are much cheaper than the specified fuse holder. The down side is, you have to solder to fix the fuse.....
They look a bit like a medium size disk capacitor.... I purchased a bunch, but I don't have the part number in front of me (that was a while ago).

[Josh]

yeah, i saw the cap type fuse, and thought about that.. i still may go that route as i wont be putting a huge load on them