Tunecast II mod. gone bad!

[Capt'n Jack]

Tunecast II mod. gone bad! While re-mod-ing my transmitter for more range with coax, the solder points on the board pulled loose. Apparently the stiffness of the coax caused the attenuator points to loosen. Does anyone know of another point to solder to for the antenna?

[Capt'n Jack]

Hard to believe old Jack's dead in the water and no help in sight!

[Pwmcguire]

The code says those who fall behind are left behind, But I'm not a pirate, so I'll throw you a line. It's probably best to start over with a new unit. Just watch the temperature of your iron, and the length of time that you soldier. It will cause the traces to pull up.