Stripboard SSR's in power strips?

[robots4joey]

I have brought up this subject probably too many times... but I would love to see a picture of the setup that the guys who have made ssr's to put in those 6 outlet power strips have.

I am trying to make the design by Robert stark; but i was going to try to do it with strip boards, and I cannot figure out the geometry to make it fit.

Any one with pictures???

Thanks again!

-Joey

[robots4joey]

Hey Joey,

Have you tried mounting it on the bottom cover of the power strip? then you could attach a separate heat sink to the triacs. I think that would fit.

If you don't understand just send me a PM or ask yourself :)

[robots4joey]

Thanks!

I'll try that!