How do I turn all lights on after a sequence runs?

[jwilliams31]

I apologize if this was covered somewhere else.

This is my first year doing this. I only have 8 channels working and I have one 8-channel sequence completed.

I would like to try to have maybe this one sequence run every 30 minutes or so and then when the sequence is not running, have all of the lights/channels on.

Thanks.

Jason

[RichF]

Create a script to turn all lights on every 30 seconds. There is an example of all off every 30 in the how to section just change the off to on.

[Macrosill]

Maybe you could have the last event of the sequence on all channels set to on. The make sure the "Reset controller at end of sequence" is not checked in the preferences section.

[Cburg]

You might also just write a sequence that is 30min long with all lights on. Then run this "All On" sequence in you program. Have you program repeat for the length of you nightly show.

Cburg