PDA

View Full Version : P5 panel matrix experiencing artifacts



kzaas
06-27-2018, 10:48 PM
I have 12 P5 panels setup in a 3 x 4 configuration using a ColorLight 5A-75B receiver board. I am using 4 outputs on the receiver board feeding 3 panels each. I then use a Raspberry Pi 3B in bridge mode to send data from Light-O-Rama to the Matrix. My issue is if i use the GIF in the link below with LEDVISION software it appears perfectly, with good motion but when I send it with LOR through the Pi, it shows a lot of what I call artifacts as you can see in the video link below. I have tried adjusting the refresh rate of the receiver and nothing seems to help. These P5 panels are the 64 x 32 1/16 scan model if that sparks any ideas in anybody.

https://youtu.be/cN_DMS4DDmw

MikeKrebs
06-30-2018, 07:22 AM
Is the gif resized or is LOR doing that?