PDA

View Full Version : Colorlight + P5 Panel



scott130377
04-29-2018, 05:16 AM
Hi. Think I must be missing something. I have a colorlight card and a p5 panel to play with. The problem I'm having is every time I turn off power I have to go through the entire setup process over again.

What I have got so far is I set the panel up using ledvision and send to card. Then I have the panel working perfect. I can display from xlights, fpp plays any sequences uploaded and the tests from fpp work great. The minute I turn off the power and switch on again the panel will not work. I go through setting up again and hay presto it works again.

I think I must be missing something????
Thanks for any suggestions.

Sent from my SM-G935F using Tapatalk

arw01
04-29-2018, 09:53 AM
Have not setup my colorlight or panels yet to try, but a fellow over on the Falcon site made up a little pdf of the process he used to get it going, maybe there is a step on there you have not noticed that causes the eeprom to store the settings.

scott130377
04-29-2018, 03:58 PM
I have seen the pdf. I will go through it again to see if I missed a step.
Thanks

Sent from my SM-G935F using Tapatalk

kzaas
06-22-2018, 07:28 PM
I have gone through the PDF step for step and I still have to set up the ColorLight every time I power it down. Has any one figured this out yet?

JonB256
06-23-2018, 06:41 PM
There is a Save config you are missing.

Sent from my SM-G955U using Tapatalk

kzaas
06-25-2018, 11:10 PM
There is a step "Save to Receiver" that I press every time I configure this thing. Nowhere in any settings anywhere is this software LEDVISION 6.0 is there a "Save Config"

scooter_seh
06-25-2018, 11:27 PM
Make sure you click "Save to Receiver" in both the "Screen Parameters" tab and the "Receiver Mapping" tab.