PDA

View Full Version : P10 panels and matrix panels equals small gap



Kev7274
02-04-2016, 08:06 PM
I used some of the original connectors (X,T1,etc) today and noticed that there is a small gap between the P10 panels. Has anybody else noticed this? Could my P10 panels not be completely square? I was thinking I may have to open up the holes a little to allow for a little more room. I would be ok with it if they are suppose to be this way.

I got the newer version of the connectors coming in a GB and am not sure it they will do the same. Thanks