PDA

View Full Version : Setup question....Please verify



Kev7274
12-03-2015, 09:21 PM
Trying to figure out how to set up the FPP. I have Vixen 3 setup for two E1.31 controllers.
First controller is setup for 24 Renard channels, I only use 11 channels
Second controller is setup for 1374 channels for my pixels,only 1215 are patched
Seperate Unicast address for both.

The setup looks funny to me?

30553

jsheehan3
12-03-2015, 09:48 PM
You can't use Universe 1 and channels 1-24 twice

You can start your pixels at channel 25 and adjust all your other numbers OR put renard at the in universe 6

Kev7274
12-04-2015, 11:17 PM
Ok,for some reason I can't get PI to work. I can can play sequences through V3 without any problems. Not sure if its maybe an export problem,etc. Check out my V3 and FPP config and tell me whats wrong. All my pixels that are run from the E682 work fine from the FPP,the renard is the problem.
30582
30583
30584

CaptainMurdoch
12-04-2015, 11:33 PM
Try setting the start channel for the Renard universe to 1275. The start channels in FPP are absolute start channels, they don't reset when you change controllers or universes.

Kev7274
12-05-2015, 12:12 AM
Thanks Captain, that worked.Was pulling out my hair.

Kev7274
12-05-2015, 09:49 PM
All working ok.