Guvner
10-16-2014, 06:59 AM
Yesterday I ordered 8 SSRneon G2-LED PCB's. On the wiki for the SSRneon G2 (http://www.doityourselfchristmas.com/wiki/index.php?title=SSRneon) there is a part that says "Change R5, R6, R7 and R8 to 330 Ohm".
Since the SSRneon G2-LED is a slightly diffirent board, I don't know if the changes to this board will be the same when I want to use it on 230V.
I can't find it on the wiki for the SSRneon G2-LED (http://www.doityourselfchristmas.com/wiki/index.php?title=SSRneon-G2-LED)
I used to think I know enough about electronics, but with these kind of simple bumps I'm not sure anymore :shy:
Since the SSRneon G2-LED is a slightly diffirent board, I don't know if the changes to this board will be the same when I want to use it on 230V.
I can't find it on the wiki for the SSRneon G2-LED (http://www.doityourselfchristmas.com/wiki/index.php?title=SSRneon-G2-LED)
I used to think I know enough about electronics, but with these kind of simple bumps I'm not sure anymore :shy: