A New Batch of Pixel Circuit Boards

[JEC]

Yesterday I received several pounds of circuit board from the overseas factory.

Specifically, I now have stacks of:

* Point Source Pixel (a 10mm RGB LED, 16F688 processor, RS485 receiver, all components surface mount)

* Half Pixel (3 banks of 3 LEDs, 16F688 processor, RS485 receiver, all components surface mount)

Note these are boards only, but I've also posted schematics & parts list on the site.

And next week I'll be receiving a new batch of several hundred assembled large pixels (cat5 cable, 6 each Red, green & blue LEDs).

http://response-box.com/rgb/?p=3

If you need anything, contact me off the forum.

John

[ben]

John would you post the BOM for the half pixel? I got 3 1/2 pixels from you and I would really like to use them. I got a dongle finally but I need the rest of the parts for those. I also need the code for them.

Ben

[JEC]

Schematic / Bill of Materials for the Half Pixel design is here:

http://response-box.com/rgb/?page_id=16

Schematic / Bill of Materials for the Point Source design is here:

http://response-box.com/rgb/?page_id=6