View Full Version : Ren XC need more help...
03-25-2008, 08:33 PM
I have everything connscted, but nothing except power led comes on. I tried the diag test and get the following:
6 on (when vixen is running)
7 on (when vixen is running)
I've tried two different computers. One has serial port onboard, the other is using usb serial port.
03-25-2008, 08:39 PM
Well LED#7 is supposed to indicate a framing error.
Did you set the baud rate to 19200 in the Renard Dimmer plug-in to match the diag firmware?
If so, maybe double check you cable & connection.
03-25-2008, 08:42 PM
Everything looks good except for the LED#7 it should be off when vixen is running. Check make sure the baud rates all match... vixen plugin, com port, and the flashed firmware on the PIC.
03-25-2008, 09:30 PM
It works, when diag code was ran, I forgot to set the computer baud rate. The real problem, I had the wrong firmware (somehow had the 115200 version)
03-25-2008, 09:34 PM
Well, its works with the onboard serial, but not usb serial.
03-25-2008, 09:35 PM
COOL! I personally would go with 57600 baud in the firmware and blink on. ;)
03-25-2008, 09:36 PM
check the com port # and baud rate make sure they match in vixen.
03-25-2008, 09:37 PM
That would probably be my fault :oops:
I have changed the firmware on the wiki to have the default baudrate set to 57600.
03-25-2008, 09:40 PM
Both com4, 57600
Powered by vBulletin® Version 4.1.10 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.