PDA

View Full Version : HLS with multiple SanDevices controllers



szaske
10-28-2013, 11:54 PM
Can someone confirm that HLS build 16R can run okay with two (or more) E682 controllers in Multicast mode? I have two E682 controllers, one setup as 192.168.1.206 and the other as 192.168.1.207. I get errors in HLS when I try to run them both in Multicast mode (sorry didn't write down the error). If I put one of them in Unicast mode and set my IP address than HLS works fine. I'm not sure it's a problem or not, but I thought it SHOULD work with both in Multicast mode. I'll ping Jim at Sandevices to see if he is aware of any problems.

-=Steve

timon
10-29-2013, 12:30 AM
That's strange since HLS shouldn't be able to tell they're two controllers when in multicast mode.

intwoit2002
10-29-2013, 12:34 AM
I am running 7san devices in MC. Be sure to check outputs. good luck

JHinkle
10-29-2013, 06:00 AM
Can someone confirm that HLS build 16R can run okay with two (or more) E682 controllers in Multicast mode? I have two E682 controllers, one setup as 192.168.1.206 and the other as 192.168.1.207. I get errors in HLS when I try to run them both in Multicast mode (sorry didn't write down the error). If I put one of them in Unicast mode and set my IP address than HLS works fine. I'm not sure it's a problem or not, but I thought it SHOULD work with both in Multicast mode. I'll ping Jim at Sandevices to see if he is aware of any problems.

-=SteveThose IP addresses you state are NOT multi-cast IP addresses --- they are unicast.

Multi-cast IP addresses are derived from the Universe number.

Joe Hinkle