bluemax
12-23-2007, 03:43 PM
Hello,
I would like to see the ability to add a D I/O along with 3 parallel port cards. The user would be able to input the Port of the D I/O card as some cards allow you to select the number you want to use. The coding for the program is identicle to the paralle port except that the port number is different. I have 3 parallel port cards along with a D I/O card which uses 252 Decimal. I wrote a program to do this but find that Viven has many of the changes that I was going to do myself already done. If this could be added then I could use Vixen to run all my lights. With my set up I am running 44 channels on a 200 htz with 32MB of ram. The code that I use to controll the D I/O card is Out 252,xx where xx is any value from 0 to 255. My program was written in Visual Basic 6.0. I have been running this progarm for 2 years now. However, I did run a simple sequence using just Quick Basic for a couple of years. RedBaron
I would like to see the ability to add a D I/O along with 3 parallel port cards. The user would be able to input the Port of the D I/O card as some cards allow you to select the number you want to use. The coding for the program is identicle to the paralle port except that the port number is different. I have 3 parallel port cards along with a D I/O card which uses 252 Decimal. I wrote a program to do this but find that Viven has many of the changes that I was going to do myself already done. If this could be added then I could use Vixen to run all my lights. With my set up I am running 44 channels on a 200 htz with 32MB of ram. The code that I use to controll the D I/O card is Out 252,xx where xx is any value from 0 to 255. My program was written in Visual Basic 6.0. I have been running this progarm for 2 years now. However, I did run a simple sequence using just Quick Basic for a couple of years. RedBaron