PicKit2 Issue

[Tallahassee Dreamer]

Ok I have followed all steps in Wayne's video's I have read the PDF I have downloaded the OS into the PicKit 2, PicKit 2 found, Placed pin in expander check communication Pic Kit found, nothing else. Should there be any jumpers on expander for Renard SS24 should I have to configure for any particular group if so how?

[Materdaddy]

If you have the ICSP14, set the pins as shown for Group C.
If you have the ICSP20A, set the pins as shown for Group G.

[Tallahassee Dreamer]

Thanks I'm caught up on "as shown" as shown where? I have ICSP20A

[Materdaddy]

Oh, sorry. My adapter came with documentation. There was a miniature CD that had the drivers, MPlab software, and a manual.

See the documentation here: http://www.joshua1systems.com/icsp-adapters/

The easiest way is to put a jumper on each set of pins that is labeled for the group. In your case, it will be G (since you have the ICSP20A). For example, the picture on the page I linked you, you will see jumpers on each set of pins for "Group D" Simply jump everything for "G" instead:
http://www.joshua1systems.com/assets/icsp20a.jpg

[Tallahassee Dreamer]

Got it first chip programed, written, verified thanks. Am I safe to remove and repeat same steps for all other chips?

[Wayne J]

Yes! ;)

Good to hear you got it. Now is will be easy from here on out. :)

[Tallahassee Dreamer]

it was all in the jumpers!!!

[Materdaddy]

Glad to hear you got it working!