Parts questions

[kiowamike]

Are these parts a match for these schematic symbols? These parts are from another project that I want to attempt. The schematic specifies part numbers for all the other components however, these are left out.84838482

http://www.mouser.com/Search/ProductDetail.aspx?R=AQV254virtualkey66710000virtu alkey769-AQV254 For the relay

http://www.mouser.com/Search/ProductDetail.aspx?R=74LV132N,112virtualkey6680000 0virtualkey771-LV132N112 For the NAND gate

[Reddy_Kilowatt]

The relay looks pretty close, but you need to guess the voltage and current rating in your circuit.

The part you picked for the gate does not match the part in your picture.

4011N is a standard National Semiconductor, CMOS logic part.

Mousers http://www.mouser.com/ProductDetail/Texas-Instruments/CD4011UBE/?qs=sGAEpiMZZMv4BkFy%252bbL2aH46LA2pMXOA%2foo%252b JCxsbw8%3d should be good.

-Craig

[kiowamike]

Here is the whole schematic. I believe there is only one volt across the relay.8484
Thanks for the advice on the NAND gate.

[kiowamike]

How about this guy for the relay?
http://www.mouser.com/ProductDetail/Omron-Electronics/G3VM-351A/?qs=sGAEpiMZZMtLEhJ5P%2fNsZw2kDgk35vSMnomnwZjq1BE% 3d

[Reddy_Kilowatt]

How about this guy for the relay?
http://www.mouser.com/ProductDetail/Omron-Electronics/G3VM-351A/?qs=sGAEpiMZZMtLEhJ5P%2fNsZw2kDgk35vSMnomnwZjq1BE% 3d

The first relay was a better guess, the Control Voltage Range on this one of 1 V to 1.3 V (what it takes to turn it on) is too low. I'm guessing it should be 5V or a little less.

-Craig

[kiowamike]

How about this one. The control voltage is 5v and it appears to be a form A or B. If I am correct, The one in the schematic is a form A.
http://www.mouser.com/Search/ProductDetail.aspx?R=AQV414Evirtualkey66710000virt ualkey769-AQV414E