Verify that the signals are getting to the com port

[njamateur]

Is there any way to verify that the output data is occuring (without a scope) My XMUS boards seem to be correct. The diag chip runs correct. Still no channel response.
Dumbfounded,
Mike

[xmus]

Is there any way to verify that the output data is occuring (without a scope) My XMUS boards seem to be correct. The diag chip runs correct. Still no channel response.
Dumbfounded,
Mike

Based on your other post, I disagree that the diag codes tell you that everything is fine. Start there :)

[njamateur]

Sorry,
Didn't realize that they work together.
Will contiue this via PM.
Thanks,
Mike

[Matt]

I used portmon to check if Vixen was really outputting data to the serial port. (It was, I just had the wrong settings).

http://www.microsoft.com/technet/sysinternals/utilities/portmon.mspx

-Matt

[njamateur]

I used portmon to check if Vixen was really outputting data to the serial port. (It was, I just had the wrong settings).

http://www.microsoft.com/technet/sysinternals/utilities/portmon.mspx

-Matt

OMG,
That is exactly what I was looking for
THANK YOU!!!
What settings did you have wrong??
Mike