I thinl I am lost?

[Doug-in-the-woods]

Going to/want? to use alternative 1 where ZC is brought in on J3 or J4 or J17
but do I still need J2 and U1?
built Ren-t using case 3
assuming I connect the ren-T to J3 or J4??or J17??
And then where do I connect the pc power supply to on the Renard64 board??
Am really lost after reading ALL the directions which are kinda confussing??I assume the Ren T dosn't supply all the power for the Renard64 espically when using the PWM firmware and leds?

[Doug-in-the-woods]

Other note I have the parts for alternative 2 as well.

[RavingLunatic]

but do I still need J2 and U1?

J2 = Yes and jumper pin 1 & 2 (both close to edge)
U1 = No


assuming I connect the ren-T to J3 or J4??or J17??
The ZC will come in on J4 from Ren-T Case 3 build


And then where do I connect the pc power supply to on the Renard64 board??

Bring power into the board where U1 was supposed to go. Pin 2 is ground, pin 3 5VDC (next to mounting hole)


I assume the Ren T dosn't supply all the power for the Renard64 espically when using the PWM firmware and leds?
Correct assumption


Am really lost after reading ALL the directions which are kinda confussing??
The info is kinda spread out in different locations. Not as complicated as toy assembly instructions on christmas morning but damn close. :lol: