Activity Stream

I did the port to v4 and the official builds are in the forkineye travis output. it is very different than v3 sw.

Thanks everyone! I do have a few of the V3 pixelsticks so just swapped my v2 one with the v3, and put my fseq and xsq files on an sd card Any...

I think it depends on how the previous sequence had the 15 snowflakes mapped. Were they addressed individually or grouped? They might not have only...

If you are asking about the AC side, you can create your own "multi-tap" using various methods. (mrGrumpy describes one above.) One male (NEMA...

yes the v4 software runs on an esp32 platform. esp32 adds a 2nd output for pixels

espixelstick V4 software runs on V3 hardware and supports playing fseq files from an sd card inserted into the v3 base card. the sw can also be...

Thanks for the replies, I was thinking more towards TM1814 and SK6812 driven RGBW pixels. I'll look into WLED and see how it interprets white from...

I believe one of these will work with Esp32 Lonlin Pro. https://github.com/forkineye/ESPixelStick/tree/unify...

It did happen, but you need to use Shelby’s ESPixelStick V3. It has a provision for a microSD which holds the sequence files Can not be done on...

Server PS . . . You need to cut off plug male plug and strip molded female ends.....and join to an incoming power cord. I join with terminal boards. ...

Using the server supplies, but will only use 120, so i will only get the 800 watts. i juts dont wanna run multiple power cords.

Yes I have. Wire the same as pixels, except the data line is G. L1 & L2 and G of Wall to first PS L1 & L2 and G, then to 2nd L1 & L2 and G and so...

When you say HP do you mean High Power or PC power supplies? and if you mean High Power, how much voltage? (in/out)

I switched to pixel icicle lights this last Christmas and I just let them hang. My wife preferred them that way and I think they look fine. I do...

Hello. I am a first time poster but I have been lurking in the forum now and then. Just wanted to comment about Ray Wu. I finally decided to try...

Update to the instructions: - Before painting PVC, instead of using vinyl to create the "candle drips" I masked off the top of the PVC with...

I would have to see the top being used. Mostly I would go to the HD plumbing department and see if I could find transition adapters. Or try to...

This is the pixel insert I used for the RBLs. Found on Thingivers. https://www.thingiverse.com/thing:3964340

I do not see that you include WLED in this reply and am curious if this would negate the user settings in WLED for RGBW pixels. The latest firmware...

Heres a side-view picture of the rooflines. Reason I felt I needed to point pixels up and get them over the roof edge is because if they are pointed...

I’ve done my icicles both ways... The first couple years I just hung them using clips and had issues with them blowing around and on top the roof...

guessing this is the link to the youtube video(haven't watched yet). My CR-10 arrived with issues:(. I returned it to AMZ. Another one is on the...

I Hope so !

Maybe not secret code, but nonsense anyway. The original question was about power isolation - ensuring that there wouldn't be any problems if the...