Activity Stream

Sorry to hear about your plight with the 20w floods . I have a few that I have left outside unused for a year or two in t200 cases . I did not...

Yes I am >>

Hi, yep everything in that post looks good. If you use 2 x 56 or 68 ohms (feed and return) then 0.5W give a good overhead even accounting for the...

You using a Wemos for that angus? I found a couple of 100 dumb nodes, but no controller for it unless I can do something

Well...disappointment wouldn't quite describe my results with these floods. I put 7 of them in enclosures and wired everything up back in the...

Okay so on closer inspection the below is I THINK how they are wired. The instructions also mention a series-parallel arrangement, without going into...

Just order a 12V 350 watt PS. You'll be able to use the extra watts when you decided to grow your display.

Careful with the terminology. The ESPs don't provide the stats on how many packets were lost. Only how many sequence errors it logged. It has no...

12V pixels are not all the same. If you have 12v pixels with built in regulators then they use (5v * 0.06a) = 0.3w * 1.2 = 0.36w (1.2 is the voltage...

Hi, I tested and ended up combining 4 strings of 50 pixels to 1 port like this: I ended up building a 360 tree with a total of 28 strings of...

No I havent. I will check them out! Thanks! Sent from my SM-N950U using Tapatalk

Did you try these? DIYLedexpress https://www.dfcco.com/

In order for a cheap led strip to work with the Philips controller it would need to be able to handle the 20V - 24V output, and it would have to...

Hey Mike, I purchased one of these MEGA 2560/ESP boards to play with because I thought it might be an alternative to my purchasing separate MEGA...

No doubt about that!

The bug has bitten you. It’s no longer just Christmas lights. It’s an obsession. Sent from my iPhone using Tapatalk

We're all iOS mobile devices in my house so I can't speak to android's behavior. But in general, most browsers these days will default to a search...

Wattage of power supply would be directly related to wattage of your bullet lights. Each 12v 12mm bullet pixel consumes 0.3W . So just multiply...

On your Pixelstick UI status page do you see a source IP and packets being received when data is being transmitted?

yes very much. He has a store to purchase x-lights sequences and effects. He does videos and webinars on use of x-lights etc. Very funny guy.

So I made a drawing of the connection I've found in the TEEs and connectors. (I got a couple more TEEs because I want to add a few more lights to my...

If I go to 5 outputs - 3 panels how and the heck to I connect the ribbon cables?

How did you determine that? I still can't connect to the E681 (with the upgrade WizNet) that I tried to add the proper 5.03 firmware to. I tried...