Activity Stream

Yup! Thats why I’m not really a fan of Mac’s. But it sure make communication with the family easy when I’m deployed.

No idea. Mine was a 2011 and used a standard 2.5” drive. But it wouldn’t surprise me.Nonstandard seems apple’s M.O. lately. Sent from my iPhone...

Would that work in a 2015 MacBook Air? From what I read Apple has their own M.2 blade design.

I have both Arduinos connected and both com ports open and I can drive each of them separately with a 5 channel Vixen sequence using each of the com...

Yes... I switched it out 3 different times thinking the same thing.

If you read the Meanwell spec document, these units require less than 3 amps of AC power. Any computer supply cord you find will no doubt meet those...

Have you tried using a different 3ft cable? There could be an intermittent wire causing signal desegregation. This would explain the need for a null...

What you've already identified is really the best practice. You don't necessarily need to zip it. Nor do you need to use the zip wizard. That's...

your approach looks good to me.

Just 20 Days remaining for this years Card swap Remember, To participate in the Card Swap PM me your NAME, SCREEN NAME (if you would like it...

It also supports 5v power input if "well regulated". I recommend using a 12v supply and allowing the on board regulator to do its job. You can use...

I use an old laptop power supply....The bridge supports anything from 7 to 24v. Look at the wiki:...

I use a 6amp power supply inside the CG1000 case with the bridge. I bought 6 from ebay for $4 each, used. Here is an Amazon link:...

Even though nothing has changed on that end? I am running the same sequence in my FPP as I was before the update. Sent from my SM-G955U using...

Vixen does not have a 300 pixel or channel limit, so the issue is somewhere in your configuration. We would need to see screen captures of your setup...

first some terminology just to get you to a point where we are all talking about the same thing: controllers have ports. a port can have many...

I am running Vixen 3.4. I am having a difficult time posting the pic of the setup. Basically, my question boils down to this, is 300 per channel the...

I am using Vixen 3.4 Sent from my iPhone using Tapatalk

If you are looking for a "stiff" channel, then you may want to look at http://www.holidaycoro.com/12mm-Strip-Ribbon-Holder-p/766.htm. We used these...

First off, you are talking which version of "Vixen"? Secondly, can you post some screen captures of your settings?

Are you saying you can plug in one (com3) and it works fine. Then you plug in com4 and unplug com3 and it works? Or do you kill the com port setup in...

Just an idea. Run the power on the outside of the channel. Get wire color to match where ever you are placing the channel and hang along the top...

Doesn't feel like timing to me. I'd guess sequencer/player/controller mismatch.

Ok, I bit the bullet and installed the new firmware tonight. I use my e682 for a WS2811 matrix. After some mistakes setting it up, I think I am...