Activity Stream

I have the same strips. They're addressable in three-pixel segments. So while you only have 50 nodes per strip, that actually gives you 150 pixels...

if you continue to have problems, a lot of people use the sketch by Victor_PV which can be found here -...

Exactly—it’s just a slim PiHat. As far as making it available to others, I’m really not sure what the best method is. I only have a few boards...

Correct. The scheduler requires something in the sequential tab. It should work with any kind of item. Even a pause. So if you do that, it will...

Sorry for bringing up an ancient thread. I have an open order with Radiant Holidays. I have had great luck with them in the past (I rather like the...

this seems like some odd behavior, i'd be surprised if it's related to the version of Vixen, as 2.1.1.0 is pretty solid. Are you running same...

Hi Martin I see what you mean and I take it the 2 that have to match are byte FrameHeader = {"FindMe"}; with the Packet Data send a text header...

Can you post a link or a picture so I know exactly what you want. I may have some.

@MartinMueller2003 That is what's concerning me. I can have the physical expansion board 100% disconnected from the main board and by flipping the...

I'm going to pull the controller down and check grounds between boards and power supplies as well as ports and strings.

If I put it only in the startup tab it is telling me I need to put at least one sequential item defined to run. Without it not working. The...

The original log posted has the startup complete and the dual pre processing and that was what I was going off of. Looks like the second posting...

But I don't have it in the startup tab only in the Sequential. I changed the time from the show now to 10 minutes and that is working. It is...

Based on the OP, He makes a configuration change and the problem goes away. Change config back and the problem appears. That tends to mean the issue...

Just curious, but I would think the log would say 'startup action complete' if it was in the startup section and not 'sequential action complete'?...

When you added the sequence files to your show did you put them in the startup tab or sequential tab? Sequences in the sequential tab will run over...

You can get dropped packets on either multicast or unicast. Any time a packet is not received due to poor reception or interference, you have a...

You won't be able to test the Renard stuff connected to USB from Vixen unless you plug that into the Vixen computer and configure the Vixen Renard...

With it preprocessing twice and the way the log reads it suggests you have the sequence scheduled twice. Once in the Startup tab and then in the...

I tryed that last night after the show was over and it seemed to work. I will have to watch some more to make sure. I also unplugged one of my WiFi...

Had the same problem on my mega tree yesterday. One of my ground lines was loose.

No, it is ran from USB on the Pi.

You will want to post this on the Falcon site. This sounds like an issue in the FPGA. At this point this has very little to do with how you have...

I changed the time to 5 minutes and removed the mp3 also. But it is still playing the show twice ? In the log file I can see twice it's starting...

In essence a really compact Pixel PiHat. Very cool.

Hi DaveMcK, The Length from the show is 3 minute and 21 second. I don't have so much lights so 3.21 min is long enough for me. But you are...

Nice design. Are you selling boards, kits, etc? Sent from my Moto Z (2) using Tapatalk

How long is your sequence? Are you attempting to run your show for only 3 minutes as a test? It has been 2 years since I used the Vixen scheduler,...

Hi, sorry about the delay in replying as I said I’m UK. Are all the pixels working in test mode now? Can you take another screen shot of the E682...