Activity Stream

I have these 24AA256 on my boards and it works. The only problem I have so far is data/ground making the lights flicker if I go beyond 5ft. If I add...

These would run espixelstick v3 firmware so they could drive ws2811? Or are they really specific to GECE only?

Thanks.... You are right about the 3 digits in the code; I noticed that as well and fixed it on my own. I've been bouncing back and forth between...

I’ll need your shipping address

The default hostname for the pIxelstick is The pixelstick product name and the MAC address. You do not need to change it but you can if you want....

So are any of these 'multiple ways' completely automatic, or does one need to do a bunch of network configuring? If it's not automatic and largely...

Thank you a lot. BTW, is there a way to control the speed of a show without modifying everything in the sequencer??

Thanks

I am using these and they seem to work also. I have several if you need a few of them also.

The Eprom I am using is a 24AA256 and seems to work. I ordered a while back, but there is some out there.

There are multiple ways to address this. The ESP has a place to set a unique host name that is advertised to your local DNS. That means you can have...

The best way to figure that out is to look at the data sheet for the one you bought. IF, you bought the one in the bom then here is the pin layout...

I'm trying to get my head around the whole matter. Is this whole scheme relying on the stable assignment of IP addresses? Are there methods for...

Actually, it does have a filter since you configure the Starting Universe and the number of Universes. Plus, you tell it how many pixels are on the...

ESPixelSticks receive E1.31 data via Wifi. As with all E1.31 receivers, it is either sent the data directly to it's IP address (so-called Unicast)...

Is there a specific orientation that the DC to DC converter goes in?

The device config page has a field for a custom name. That name is sent to the router and to the FPP master. There is no filtering built into the...

It was either a solder bridge or a poorly soldered connection. I reflowed a couple of different joints.

For future reference, what did you find?

Nevermind, I downloaded Kicad and apparently they haven't used .brd files in awhile. Oh well, it was just a thought.

Are you sure those are Eagle files? I think Kicad also uses the same file extensions. I don't have it installed so I can't try.

There is something hokey about the first set gerber files that were bandied about (their gerber viewer said that it couldn't find an outline layer),...

It's completely FPP operated. All you need is the BBB version of FPP on a sd card (V6 is out now) installed on the BBB, Connect it to your network...

You are welcome. Glad to hear that both PixelRadios are working. - Thomas

1 & 5, The DC to DC converter goes in the 7805 spot. 4 I'm working on putting one together using a deferent EEprom I'll let you know.