Activity Stream

If they were wrong in the first place when you brought up the Visualizer, that would do it.

Cat5 is like a poor-man's version of a receiver. You could hack Cat5 and make it drive 100 feet, but why?

brand name? picture?

Here is a shot video of the prototype:

Agree, this is most odd. If you have a Pic Kit, you might reflash all of the pics.

I wonder if there is anyone alive who remembers the 1927 Nova Scotia hurricane.

This is all very odd. But first, I want to make sure that we're talking about the same board. Is it the RevXC5 board shown...

We are West of Savannah Georgia and we are currently looking for Tropical Storm conditions about Friday. Years ago when Matthew stayed off the...

Cleaned the board, reflowed some of the solder on a handful of rough pads and results are the same. Here are the dead channels. 29 31 32 34...

Well,moved the little resistor today and it wasn't as bad as I thought it would be. Solder job looked pretty good. Flashed the board and everything...

Interesting thing I found that works, I used the visualizer feature in xlights set my props to ports, then uploaded again and now everything looks...

If both the LEDs (without SSR cables plugged in) and the SSR channels (with the SSR cables plugged in) are non-responsive (and the bad channels are...

What if you wanted to work on the same file at 2 different locations (PC's)? I have copied the entire directory each time before opening. Is there an...

And the quality of the cable and NOT running pixel power through the signal cable.

I experimented with my PixelPi project (Kickstarter) and I had 100' of CAT5 driving with no problem, and used a line buffer to drive it. So the real...

Or maybe corroded.. I like the clean with alcohol and reflow the joints described above.

Take a look inside the 64's SSR jacks. Are any pins misaligned or out of place? -Craig

When you say random bad channels, are these all in a row or spread out? If they are spread out, and if, when you swapped pics, the bad outputs...

Sorry folks everything has been sold

This is something I want to incorporate to next years show is having projection video play on the garage door together with my Vixen sequences. Is...

Thanks ctmal. Right now I have 2 short pixel strips hot glued top and bottom of the window. wire extensions soldered to the end of the border strip....

Another long shot is that you didn't Render All right before uploading. If it's not all rendered yet, that can cause weird things.

I attached the Wiki troubleshooting page. It may help, but it appears to focus on PIC problems. Here is the schematic. You may be able to check...

Tony, Thanks for the reply. Sadly, when connecting a known working SSR the corresponding channel(s) remains dead.

Jacob, I have a couple of banks on some REN64XC's that appear bad, aka, the LEDs don't light. However, when I hook an SSR up to them, they fire...