Activity Stream

Good job. Curious why you went with 30 universes.

4 pages , 2 days and still no blinky . Use the esp flashtool and load the .bin file within the folder dist Cheers

snippet from your espixelstick.h Martin can get a bit murky . #include <Arduino.h> #if defined(ARDUINO_ARCH_ESP8266) # include...

The error clearly states that the missing lib is "AsynTCP" yet you downloaded and highlighted AsyncUDP which Quoting Martin , make sure you dl and...

but if I remove it from the Libraries folder I still get the error In file included from...

If this is the case and there will be conflicts , would it not be wise to include "ESPAsyncUDP" rather than <ESPAsyncUDP> and have it in the sketch...

Capacitors serve two functions (mostly), that of being part of filters and that of being a reservoir for drops in voltages. So in this case, the...

The error clearly states that the missing lib is "AsynTCP" yet you downloaded and highlighted AsyncUDP which is NOT listed in the readme and is NOT...

I know, and it does exist in the arduino/libraries Directory of C:\Users\scott\Documents\Arduino\libraries 05/26/2020 12:38 PM <DIR> ...

When I did mine I only attached the top zip ties between the pieces and didn’t do the rest until after I had the fan tensioned. Having that extra...

Thanks. I'm having a little trouble getting the coro to line up with the pvc on one side. I may throw some heat to it and form the arch and take some...

I have seven of them and not only do I run the fan and arch all off one power supply, I also run either one pixel pole or chromabulb off it as well.

U-bolt is 1/4 thick x 2 1/4 wide x 3 1/2 tall. It is placed in two holes drilled through the center of the pipe. Base pipe is 6’ exactly. 1/2...

that is a manually dowloaded lib. is it present in arduino/libraries

Yes, I went through each step in the Readme. very carefully on another note.. GULP went down ok

Have you gone to sketch/include library/manage libraries and installed all the needed libs ?

Ok, I got the LOLIN D32 PRO boards in today, I plug it in to the USB and this error started again... Whiskey, Tango, Foxtrot Over !! In file...

Sorry I cant help on the smart receiver problem but... I must apologise I think I sent several messages to your private box, responding to your...

I have gotten what I needed. Thanks!

I was planning to do that, I layed out the Strips and put them together and each strip got dimmer so I wired the Strips to have that capability I...

I agree with Martin adding fused injection wiring to the input of all secondary strips is best method .

http://doityourselfchristmas.com/forums/showthread.php?54673-Something-different

You do realize that you will need to inject between each set of strips and yes adding a cap will not hurt.

The next big hurdle is getting gulp installed and working. There is a seperate README for that.

You are correct. I will add a note for that.

Post screen shots of the setup for you falcon and you xlights controller an model setup tabs

Well I did a complete un-install, deleted the folders in the Programs and in the Registry. Starting fresh. installed only what items that are...

1St reaction - WAAAAAYYYY Cool. 2nd reaction - OMG how many PSUs would I need to do that for 5 arches. Head exploded.