Activity Stream

Thanks for trying this. I have sent you an address to which you can send a copy of your file so I can try to debug your issue. You do need to ensure...

Still good info if nobody is getting rid of their show this off season! I appreciate it.

I'm having a hard time getting this working... If I set my Second input mode to Effects, and my First output mode to WS2811, I can get effects to...

Edit: disregard this reply because my response was getting parts new and didn’t realize that OP asked of someone letting go a controller and pixels. ...

I didn't realize that was an inherent condition of e1.31. Same issue when FPP is turned on. And yes, disabling source 1 input allows Alexa to...

Yep! Never-Seez!

The Pacific NW CLAP "Mini" is open to all who are interested. The date is Sat May 1st. Set up and Pizza Meet/Greet is on Friday the 30th. We will be...

If you configured it to look for E1.31 then it will process E1.31 data. You have the option of selecting "just" one data source.

hmm...good point. If using Alexa configuration, I wouldn't think it should be looking for e1.31 inputs.

When you configure multiple inputs, things can get "Odd". E1.31 will override the secondary data sources, but once E1.31 stops it goes back to the...

V4 is good stuff, but running Vixen 3 with V3 Hardware being controlled with V4 (Travis) software and Alexa has issues. like running FPP and using...

Try lithium grease or never seize !

I have also tried to use light weight oil to the threads, however it never worked out!

You can see the readme here: https://github.com/forkineye/ESPixelStick/tree/unify

Thanks very much Martin .

Here is a snippet from the Forkineye Release page . Our efforts have been focused getting on Unify (4.0) ready so that pretty much wraps this up....

I'm a bit confused, I only see Release 3.1 or 3.2 on these github sites. How do I find the v4 release of the software?

Very Nice Gesture - Good Job!!!!

As ben&bobbi posted I did a very similar thing, because my ground is not level and I wanted the tree to be straight. If you have flat (level)...

ok. So each string is for 1 2' tall mini tree which will line a walkway, so 10 per side (2 runs). I'd rather not have 2 power injections on each...

That is what my calculations come up with as well: 4.27V at the end of the string. But this assumes the wire is actually 22AWG and there is no leader...

I thought I had the DMX working on the v1 PCB's I have. I did switch port 1 and 2 at some point, but I looked at the schematic and it looks correct....