Activity Stream

Do NOT use USB tethering on the K4. That will cause damage to the board. What WIFI adapter are you trying to use? Many don't properly support...

My k4 has a ip of 192.168.8.1 but i cannot connect to it I have try a different usb dongle and still no connection. when hook up directly with...

Nice to hear from the man himself!! I was thinking about that as well. More or less curious how the cold would effect those switches. Good trial...

Very nice... It takes time to learn the sequencing. Also being my first year (but started in mid Jan), I learned very quickly to take advantage of...

A couple of cheap switches ( like https://smile.amazon.com/NETGEAR-5-Port-Gigabit-Ethernet-Unmanaged/dp/B07S98YLHM which can run from a 5V power...

Thanks for the feedback. Using one or two Kulp controllers seems like a cakewalk connecting them to a router. My yard is a corner lot and we decorate...

Ok just found the xlights zoom room ...awesome! Thank you! They were able to help me in about 4 minutes flat!! Awesome guys too! Thanks again!

I have multiple Falcons and multiple Kulps. Both are great systems. I?m using more Kulps right now. Using a controller that doubles as an FPP...

WLED shouldn't need more than 7 segments to control that "box". Anything else gets kind of messy compared to the ease of WLED. That said, either...

The original song appears to be here: https://soundcloud.com/elizabeth-hayhurst/hey-come-look-at-my-house

There was spot where you did the dark to light thing. That was good technique. With only one song, hard to do but don't use everything in everything....

Thanks for the reply! There is some stuff going on there, twinkling lights on the mini trees and lots of moving circles on the megatree. I'll look at...

Yep. We have figured out about 50% of it, and they (we have two) are pretty much center of our display. (Along with two Showstopper Snowflakes). ...

It all comes down to how you want to setup your show. For us, we went back to a single RPi sending E1.31 and DDP across a wired network. We had...

Very Good. Now get those lights set up!

I think you did a very good job sequencing. The only advice I'd have for you is don't be afraid to use a little more motion and flashing, especially...

I still do a show network as I prefer to keep my blinky stuff separate, but it's unnecessary. Master/remote won't clog up your home network.

This song is great!

or be ready to replace a lot of dead pixels exposed to the heat going up and down over and over again up the house is my ptsd showing i'm not sure...

I am happy with my twin K32's. They co-operate with smart receivers,.Renards, and DMX, the single network jack goes directly to the router in both...

I use a K8-PB and a F8-PB in remote mode in my setup

You graciously called and talked with me on the phone a few months back. Working absolutely great in my show this year.

Just wanted to say.. make sure whatever you do, you plan for being able to replace dead pixels here and there.. don't make it "too permanent"

I re-uploaded the v4.x firmware to the Pro using Espixelstick as hardware. Although it uploads and connects to the network as indicated in the log,...

I will go hide in shame now. I checked this troubleshooting step earlier in the process, so something else must have been wrong that was fixed...

Time to get into serious diagnosis mode here. Do you have a multimeter? You should begin with measuring if you have voltage at the phoenix...