Activity Stream

You would still need to inject every 70" or so

Glad to hear someone say that they are not getting same numbers... I like the suggestion "if it works, go have lunch" and I have been sort of doing...

This is probably the best one. https://www.youtube.com/watch?v=eR3QbzjpZy8&t=1416s

Dan, I am outputting from xscheduler to 3 Video Matrix Displays (2 - 43" and 1 Projector) using (3) Pi 4s in Player Remote mode. The Matrix...

Thanks! So the strings will be 30 LEDs with 10" spacing, Total of 25'. I am hoping I can get 90 LEDs (3 Strings) per power drop, more would be...

The wife and I's first time to go, looking forward to it.

Why is your fseq file 4.5GB in size? I've never seen one that large. Even the massive drive through shows with ~2M channels and a long sequence...

Have you tried using compressed fseq files

Tried a full sd format and install of FPP onto a new microsd. Under the Storage Tab, I selected the USB Stick that I had plugged into my Pi 4. ...

The Starter Kits are out of stock. The price chart is what I update. :)

Whether custom built or off the shelf, The tri colored LEDs will draw current. You use the correct value in your power calculations Keep in mind that...

Any update on this? Very interested in doing similar. Looking at the single stage ASAP Sr pole secured into a permanent ground sleeve. Hoping...

Don't see where you can have 2 file locations, but you can use either the microSD or a USB drive for storage Insert USB, go to FPP Settings, then...

Did you use Krylon Plastic paint ?

I did the port to v4 and the official builds are in the forkineye travis output. it is very different than v3 sw.

Thanks everyone! I do have a few of the V3 pixelsticks so just swapped my v2 one with the v3, and put my fseq and xsq files on an sd card Any...

I think it depends on how the previous sequence had the 15 snowflakes mapped. Were they addressed individually or grouped? They might not have only...

If you are asking about the AC side, you can create your own "multi-tap" using various methods. (mrGrumpy describes one above.) One male (NEMA...

yes the v4 software runs on an esp32 platform. esp32 adds a 2nd output for pixels

espixelstick V4 software runs on V3 hardware and supports playing fseq files from an sd card inserted into the v3 base card. the sw can also be...

Thanks for the replies, I was thinking more towards TM1814 and SK6812 driven RGBW pixels. I'll look into WLED and see how it interprets white from...

I believe one of these will work with Esp32 Lonlin Pro. https://github.com/forkineye/ESPixelStick/tree/unify...

It did happen, but you need to use Shelby’s ESPixelStick V3. It has a provision for a microSD which holds the sequence files Can not be done on...

Server PS . . . You need to cut off plug male plug and strip molded female ends.....and join to an incoming power cord. I join with terminal boards. ...

Using the server supplies, but will only use 120, so i will only get the 800 watts. i juts dont wanna run multiple power cords.