Activity Stream

It's got to be your patching if it isn't working from Vixen. I think you need to forget about the future and what you may or may not add and work...

Thanks. I wasn't thinking power, but after going back and doing the math I realized that I'm going to need 2 PS for my Matrix. Thanks again.

I run Renard SS boards right from a 682 or 6804. With the 6804 you just need to designate which output is Renard. With the 682 you need to put a...

Ready to throw it all out! After a rain delay, I removed the Pi as my controller and now plugged directly into my PC (via USB), went back through and...

Is there a way to save a corrupt sequence?

OK pulled an re-seated the chips reflowed every solder joint re-flashed with 5.030 Device name error persists, and I am getting output through...

Hi, my mind got to thinking about this again today. I played with some 32V AC strings earlier this year (or last I can't remember) the schematic is...

There's no problem with doing it that way. Just wanted to make sure you knew that that is just a name for the interface and has nothing to do with...

None of the controllers (except FPP while running as bridge) do a full IGMP implementation. So the IGMP level doesn't really matter so long as it's...

On/off effect with a single color applied to the whole model repeatedly should work. If the transitions are too hard, you can mess with the in and...

Thanks guys, I was able to move the profile to a new computer (which was my initial plan before messing with the location and giving myself a mild...

I checked my UniFi controller setup. Both of my APs are set up (under General) to use site settings. Then in the controller, global settings at the...

I'd be interested in this too. I have a relatively simple show: basically I have strings of christmas lights that look normal, then the grinch...

Thanks for the advice. I’ve had some success with the “single string” and even “strobe” effects with some tweaks, but nothing super close to what I’m...

Could it be a power issue? I have some snowflakes that I had to limit brightness on because if they all go full bright then they lost power to the...

I had to replace the R-packs on my E682s to get them to work reliably. I used these: 33 Ohm 8 PIN SIP RESISTOR NETWORKS ISOLATED CSC08A03-330G...

The last two images are a fresh upgrade on the e6804 to v5.030 first image is default settings. nothing changed. Note the "Controller name" error...

Hi. It's a pixlite 16 eco

The 682 will do 7 universes in multicast and 12 in unicast. I noticed your Vixen setup has 15 universes. Sent from my SM-T710 using Tapatalk

I had the same issue and I injected at the end of the string and issue was resolved. I did have my 682 slightly more than 10 feet from tree. Each...

Yes, years ago, never had an issue with it. after the upgrade, you can see the configuration page shows a few problems.. beginning to...

Tried that and it makes it not work. Pretty sure that blocks all the incoming lan unless you have an exception configured. I don’t because I’m not...

Does the controller indicate it is receiving packets on the universes that are configured and they increment while Vixen is running with the...

If you look in your My Documents\Vixen 3\logs folder, there should be an info log. In there will be a line that looks like the following. ...