Activity Stream

Try looking up 'DDP E131' or 'DDP Setting" on this site, I think the in-site search function needs more than 3 letters in the search request.

Yeah you could be right. I may try the xlights zoom again and see if anyone over there knows. I think I'm going to add in my pi anyways. My only...

Need more info on what these options mean. Option 1: What is DDP? Is that a setting in FPP? Option 2: My complete show is wireless. I got...

I don't have a Falcon brand (although I want one...) so I can't know for sure, but I do see Xlights clearly has "Falcon, F16V4" as a valid, supported...

What I did was, I used 50-pixel strings. The shared PSU's are 100 pixels apart. When I probe voltage in the middle with all pixels off, the voltage...

Buy them from Ray Wu. They are not that expensive, and will save you tons of time.

The alphapix should need to start at universe 2 but for a wired network, no reason not to do that for clarity in your mind.

Which channels are wifi and which are for your fpp? Are you using one of the FPP as your player or something else? You could introduce a second...

Here is a shot of the 100 5 pixel stakes. Short test video.

Yes to both. I can upload output without a problem and the Falcon UI opens. It's like it half works. I know the easy answer is to use the pi.....

Sounds like FPP Connect is not so successful. And Xlights isn't talking to your controller like it should. When you go in Xlights in the...

I was, those guys are super knowledgeable. A combination of configurations with the controller itself and changing from E131 to DPP, v2 uncompressed,...

1.) FPP connect is successful, in that it allows me to select a sequence, and upload it without error. However, I end up having to upload the .fseq...

the 01 version does not have enough i/o pins for an sd card.

It's likely not possible if he's got older hardware with no SD card support I believe it's possible to compile for the 4MB ESP-01 variants. The...

there are a ton of esp based controllers

Ok, I finally found where to set the IP address... it was hiding beneath the "Destination" button (a bit vague). So now the tree is doing the light...

A few questions from me: 1). Are you successful using FPP Connect (the Xlights menu) to upload your sequences? Or do you do something different,...