Activity Stream

Thanks so much! Transformer is I believe a normal 'wall wart', I measure 24v on the output terminals with a voltmeter with no load. I think I...

haha that was pretty sweet

How about about $3 to $4 cheap? I'm running 18 strings of 50 with a single nodemcu ESP8266 running ESPixenStick v3 firmware. I'm not doing anything...

The export wizard places the file where you told it to save it. My places the fseq files in the Vixen/{profile name]/Export/sequence directory ...

Seems I have two dead Wiznet 820io's /sad panda

All my E682s are set at 50%. I could probably drop down to 25% and still be bright enough. However, there is a street light right on the corner next...

I'm debating on putting little fans in my CG-1500 boxes. I am running 2 12V PSUs and a E682 controller board in each. After the show has been running...

yes, I meant 20fps...sorry about that! :)

I run mine at 10%. Plenty bright and it cuts down on the number of injection points I need.

maybe he meant 20fps, which = 50ms.

No, the default timing is still 50ms. At least it is in mine -- I'm not sure if you change it and then close the program if it pulls up the last time...

The 90 degree pattern isn't a hard line. The signal is still present outside of that angle, just at a much lower strength. If you're fairly close...

20ms is the default in xLights now? That's 50 frames per second. That's a pretty high rate. Glad to hear you figured it out. I'd never have...

So I was able to figure this out, and get just the sequence to work. My first attempt at doing so, I made the sequence in xLights using a custom...

You may want to update your FPP version. There's some things on that screenshot that don't look right. I don't know what that last column is in the...

I’ll try moving the AP to the corner of the house. The only concern I have with that is if I’ll be too far away from the porch controllers and the...

Yeah I tried doing just the sequence as well, but it ended up just skipping the sequence and played the next thing in the playlist instead. Here is a...

when you made the changes on the AP, it would have flushed the IP addresses (ARP table) in the AP. It won't relearn the IP of each station until you...

It should work. You can schedule a sequence and media, sequence only, or music only items. You shouldn't need a silent MP3 file. A "sequence only"...

Here are a couple screen shots. I guess the changes we made earlier stopped the recording of IP addresses on most of the station listings.

I was just afraid to cause a problem taking the screen capture. I have it just need to get it off computer and send it Sent from my iPhone...

Generally the nanostation is still better performing. You don't need to wait for a slow time to get a screencap from the AP. That shouldn't...

Just a curious question..... Has anyone attempted to run FPP on a BeagleBone white? It seems to be almost the same as the black version, but...

Hi, just a guess / thought based on stuff and a couple of beers (it’s late UK side). What can we pick out of this? A white LED needs at least 3V...

I generally run at 10-40% depending upon the prop. I ran my whole display at 10% last year for taking video. It looked fine so I just left it there....

Would it be better to have a picostation than the Nanostation? I’ll wait until a slow time in cars and get a new shot of the station data. ...

Just watched a couple songs and it is much better. Normally on only have two small cars parked in driveway. Van is in garage. Sent from my...