Activity Stream

That is perfect... THANK YOU!

Great thanks Sent from my iPhone using Tapatalk

All my 682's are version 1.3 and do not require a shunt. You have something else going on. Sent from my SM-T710 using Tapatalk

Voltage at j3&j4 is 12v j1&j2 nothing

Yes power on both sides fuses are all fine

If your entire string is using a single PSU then you doo not need to cut the V+ line in the string. 5V pixels use 0.06A per pixel. That converter...

xlights, vixen, lor, pretty much irrelavent. What serial protocol are YOU planning to use to go from the show player to your controller? That drives...

Do you have power to both sides of the board? Check your fuses. If you're powering the board and pixels with 12 volts make sure you have jumpers...

I'm not familiar with xlights but what sketch are you using ? I use vixen lights and the sketch I'm using works fine I just set it up as a generic...

So I found some other converters I’m thinking of using as the 3 amp ones only do so many . If I use these I should be able to run a full 150 5volt...

Thanks B and Yea the 50 amp one has a shunt with it , think I’ll get that one . Sent from my iPhone using Tapatalk

With a shunt

We added a "Random Start" checkbox. If you uncheck that, two sliders will appear allowing you to configure the initial X and Y position of the...

...and sure enough, I needed to change a unit ID. Put LOR on my work laptop, then found 3 sequences I had timed to the music. So, bonus. Jeff

As always, beautiful display William. Them pixel trees are awesomesauce. Jeff

Sent from my iPhone using Tapatalk

This one actually goes to 50amps Sent from my iPhone using Tapatalk

Anyone know if this display would work as I’d like to know amp draw aswell ? MCIGICM 0.28" LED Voltmeter Ammeter, Red and Blue Digital Multimeter...

Great thanks ...wanted to be sure before I ordered Sent from my iPhone using Tapatalk

It is a 1 in 4 out power distribution board. You supply it with 12v or 5v and get 4 ports out to be used for injection. I used several in my...

I was putting together my box and found this on my diagram so searched and here I am still trying to figure out why I need these , could someone help...

Can almost guarantee you will have a failure in the added power distribution complexity of 5v before a resistor would fail on the PCB. failues in...

Um, you must be missing what I am trying to do. This prop is a hedge covered with a net light, which is a matrix of pixels. It is too large (1200...

Awesome! Thank you for the information. I just got a case out and started the layout to put the 4-port RPM bridge into. Over the next couple weeks I...

The other thing you can do is just define one output controller in vixen that sends data to all of the physical controllers. You'd need to use...

The clues will be in the fatal log. Post it here and we'll help interpret it for you.

yes you can run both. You likely already have both kinds on the network, with broadcast as well. Things like mDNS and Bonjour already use multicast....

Me trying to power inject from one location would look like a remake of an old invasion of the spiders movie hahaha Sent from my iPhone using...