Activity Stream

From your photo (post # 14) ,the data wire appears broken about 3/4 inch back of the solder pad .

Did you connect the groung (-) from the dig and the 12v ps? The ground that the data device is connected to must be connnected to the ground on the...

Her is a picture from the end I connecting to

Can you take another photo ? This one has much to much white in it .

Here is a picture of the strips from the end I’m connecting to

If you look at the strip like this should say 12 v or 5v Sent from my SM-N975U using Tapatalk

So I was reading your post again is the ws2811 a 5v strip or a 12v strip what is stamped on the stip Sent from my SM-N975U using Tapatalk

I just tried connecting to other end and won’t even power up here’s a picture of connections to node mcu

Bump. Still have a lot of the power supplies. Make me an offer

I’m going to try that in a bit and I will post my results thanks guys

I have a set the I got that was labeled wrong I just put the data line on the other end and it worked Sent from my SM-N975U using Tapatalk

10-4 I didn’t catch that yes I’m on data in the end with the arrow pointing towards the far end of the strip I tried all 5 strips but you got me...

The question was: Are you sure you have the data line connected to the correct end of the strip. The strips have data in at one end and data out at...

I didnt end up frying anything.. Just blew a fuse after putting it in the wrong location, whoops!

I have everything disconnected right now but basically I just disconnected my 5 volt pixels used the same data wire I used with them and connected...

Any pics of the connection make shore you are on the data line in side. Sent from my SM-N975U using Tapatalk

I still use Vixen 2.5 and I felt the same way when I tried Vixen 3 when it was first coming out. I felt like it was mostly focused on pixel control...

I was able to swap my Wizio modules around when testing the e682 beta firmware from Jim I now have an e682 using the cheap W5200 clone module and...

Steve, did you get any of your bridges working? I have some things that might help if you need them. I’ve got a spare RPM that works, but one port is...

Cheapies! In 10 years I don't think I've ever changed one out.

Bump

I started with generic 350w supplies. 2 of them within 2 years had trouble. The large Capacitors swoll up and let the magic smoke, or steam, out....

I'd be curious to know.. beyond the sequencer.. What LOR hardware are you using??

A combination of generics and people's wall bricks that they aren't using anymore.